On Sun, 8 Feb 2004 15:30:09 -0600, James Nick Sears wrote: > I learned of frontpanelexpress in a thread here a while back and it looks > like a great service that I would like to try (same for emachinesop, > which > was discussed in the same thread) but this project has to be watertight > so I > can't really use a front panel, per se. > > But could I send my aluminum enclosures to them (or even just the lids) > to > have lettering, logos, etc. milled and anodized? I looked at their > website > and it shows a pic from a screenshot of their application that shows a > "Use > customer's material" checkbox, but I can't find details on the website on > the limitations of the supplied material. > > Thanks, > Nick You ought to investigate laser engravers in your area - have the whole thing anodised and then have the lettering or whatever laser engraved into it. it gives a much nicer effect than milling and is probably cheaper too. Regards Alex -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.