I have an mpu with ADC and a couple of pressure sensors connected to the =
ADC through about 2" of wire.

I have found that using sheilded wire helps in noise reduction.

The sensor manufacture recommends an RC network on the output using a =
750 ohm resistor and a .33uF cap, but doesn't specify what type =
components.

What type capacitor would be best, and a second best?

Would any type resistor work well. Would two resisitors in parallel work =
better than one resistor or two in series to form 750 ohms (hard to find =
locally), as far as not picking up noise?

It would be easier to put the rc network at the sensor. Would this work =
as well as putting the rc network near the ADC?

Thanks for any help.

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body