Were the ICD-2s working with another family (18f) of chips?

MPLAB updates the firmware in the ICD-2 based on the chip you're using it with.
Not at a machine where I can test to get menu picks right now.


-----Original Message-----
From: Harold Hallikainen <harold@HALLIKAINEN.COM>
Sent: Dec 31, 2003 5:06 PM
To: PICLIST@MITVMA.MIT.EDU
Subject: [PIC:] ICD-2 and 16F628A

 I am having a problem with the ICD-2 and a 16F628A. I've tried two
ICD-2s, and they both exhibit the same effect. The ICD-2s have worked well
on other chips. The ICD-2 is connected using USB, Win98SE, MPLAB 6.40. In
each case, I get

Connecting to MPLAB ICD 2
...Connected
Setting Vdd source to target
ICDWarn0020: Invalid target device id (expected=0x89, read=0x83)
...Reading ICD Product ID
Running ICD Self Test
...Passed
MPLAB ICD 2 Ready


There are switches to ground on RB6 and RB7, but both are open. There's a
10k from -MCLR to +5V. This does not exactly duplicate the -MCLR wiring of
a PIC demo board. Is it possible this difference on the -MCLR wiring would
cause the device id problem?

THANKS!!!

Harold


--
FCC Rules Online at http://www.hallikainen.com/FccRules/



--
FCC Rules Online at http://www.hallikainen.com/FccRules/



--
FCC Rules Online at http://www.hallikainen.com/FccRules/

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body