Thanks!!  This group is great!!!

I can't seem to get the 1khz calibration signal to fit into one division...=
.so it's taking up two for a full cycle.  Is that normal?

I was considering using a pic for calibration.....but my on, off, goto =
label was not even...the "goto label" was taking time and made the off =
pulse a bit longer, not quite twice the "on" pulse.  I wanted a clean 1 uS =
signal to play with.  (It's a 4 MHZ PIC)

Can I do=20
boringloop:
on
on
off
goto boringloop

and get a clean 2us signal....or 4 us square wave cycle??

Thanks again for all the help!!!
Tim

>>> bbarr@CALIFORNIA.COM 12/23/03 02:47PM >>>
On Tue, 23 Dec 2003 15:28:55 -0500, Tim Hart wrote:

>That part I might be missing is "Per Division".  I'm not 100% sure what =
each division is.  I have no book on this one....it's learn as you play :)
>

As you look across the screen, you'll see 9 vertical lines dividing
the whole sweep into 10 equal pieces. The space (i.e. time) between
each of those lines is referred to as a "division". So, when you're
set to the max sweep rate of 0.05 uS/div, the total sweep time is 10
times that or 0.5 uS.

>The 10x mode is confusing....it samples the same....so is the signal any =
different?  Just closer right?
>

Yep, you just get a closer look at the center 10% of the screen.

>Anyone know of a good starter site?  The 1,2,3 at Tek's website didn't =
cover calibration or what each division was....
>

Sorry, I don't have a recommendation for a web site. I'm sure that
someone will, though. :=3D)


Regards, Bob

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads