That part I might be missing is "Per Division".  I'm not 100% sure what =
each division is.  I have no book on this one....it's learn as you play :)

The 10x mode is confusing....it samples the same....so is the signal any =
different?  Just closer right? =20

Anyone know of a good starter site?  The 1,2,3 at Tek's website didn't =
cover calibration or what each division was....

Thanks,
Tim

>>> rammerman@COPELANDDATA.NET 12/23/03 01:58PM >>>
> Also, don't forget - that 0.05uS setting is the time *per division*.
> There's room for a lot of cycles in each division. :=3D)

And, you can also engage the 10x sweep expander to get 0.005us / div.

Also, remember a 100Mhz vertical bandwidth means the scope isn't going to =
be
able to display a 100MHz square wave cleanly. It will end up looking a lot
more like a sine.

Bob Ammerman
RAm Systems

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads