Question on using TOCKI to feed TMR0 for an F84A.

- I assigned the prescaler to the WDT since I wanted TMR0 increment 1:1
with each low to high transition on TOCKI.  I also set the OPTION reg up so
that TMR0 source was the TOCKI/RA4 pin, increment on low to high transition.

- Running MPLAB IDE sim however with the pin stimulus setup to toggle
TOCKI  or RA4 with each instruction showed that TMR0 would NOT increment.

To debug (in case I did not have the simulator setup right) I ONLY changed
the source of TMR0 to increment on clock cycles instead of TOCKI.  That too
showed that TMR0 would not increment.  I could only get TMR0 to increment
if I assigned the prescaler to it, and then the lowest prescaler value was 2:1.

Am I doing something wrong?  Or is there a  bug in MPLAB IDE? (ver 6.3)

Thanks,

Dave

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads