I have a warp13 and have never had a problem.  It worked first time and
hasn't failed yet.

But you have to careful with devices that directly access serial ports on
Windows 2000.  If this device was sensitive to that, there must have been
something in the installation notes, because I don't remember any problems
installing it.

Bruce Partridge
http://www.rebreather.ca

> -----Original Message-----
> From: pic microcontroller discussion list
> [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Jean-Michel Howland
> Sent: Monday, December 22, 2003 9:10 AM
> To: PICLIST@MITVMA.MIT.EDU
> Subject: Re: [PIC]: Warp13 error
>
>
> >I have recently purchased the Warp13a, --the worst programmer I have ever
> >laid my hands on-- and it does not work.  I keep getting the
> following error:
> >
> >Cannot get CTS permission to send byte, Aborting operation
> >
> >Anybody have any idea?
>
> I own a Warp13 and its worked *perfectly* over the last 3 years.
>
> I would take a look at the RS-232 side, check the cable, the DB-9 on the
> board etc. as it sounds like you have flow control issues.
>
> Regards
> Jean-Michel.
>
> --
> http://www.piclist.com hint: To leave the PICList
> mailto:piclist-unsubscribe-request@mitvma.mit.edu
> ---
> Incoming mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.543 / Virus Database: 337 - Release Date: 11/21/2003
>
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.543 / Virus Database: 337 - Release Date: 11/21/2003

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu