If you decide to stick with the metal cutting shears then try
http://www.buitelaar.nl/i-index.html under 'plaatbewerking' and 'HBM
handschaar'. They are in Waddinxveen, 50kms or so from you, very helpful
too.

Simon


-----Original Message-----
From: Wouter van Ooijen [mailto:wouter@VOTI.NL]
Sent: Sunday, December 21, 2003 8:17 AM
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [EE:] cutting PCBs


> Depending on how large you need, a shear isn't really
> terribly expensive.
> I don't know what that sort of thing might cost in
> Amersfoort, but on this
> side of the pond a shear capable of cutting boards perhaps
> 200 mm wide or so
> only costs a little over 100 euro.  As you go wider, though,
> they do go up
> in cost pretty steeply.

200mm is OK, but where can I buy these things? The supplliers I know
don't seem to offer these things.

Wouter van Ooijen

-- -------------------------------------------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu