Denny, I use a laminator that I had purchased from a company called dynaart (www.dynaart.com) about 4 years ago. Apparently they take a standard laminator and make adjustments to it in order to accept different board thicknesses. As I recall, they also modified the thermostat and the feed rate to optimize it for the thermal mass of the copper board and the heat resistance of the toner. In any case, it works very well. Looking at their web site, it appears that they have changed manufacturers so the new units may work differently. About $150.00 and does up to 8x10 boards. Ken ----- Original Message ----- From: "Denny Esterline" To: Sent: Friday, December 19, 2003 2:58 AM Subject: Re: [OT:] First homebrew PCB - success! > I was just out looking for a laminator for this very purpose. Any > reccomendations? (make, model, cost, modifications?) > > -Denny -- http://www.piclist.com hint: The list server can filter out subtopics (like ads or off topics) for you. See http://www.piclist.com/#topics