Wouter & olin

despair bring ppl to do some funny things :-)
the auto route is so limited! (in my opinion) I can't understand sometimes
the logic behind it. a very simple routing is made so clumsy by eagle that
sometime like in my case I need to do some manual routing.

but I will use your suggestions and see if it work for me.

Thanks to all of you

Tal

-----Original Message-----
From: pic microcontroller discussion list [mailto:PICLIST@MITVMA.MIT.EDU]On
Behalf Of Olin Lathrop
Sent: Sunday, December 14, 2003 11:00 PM
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [EE]: Eagle HELP! URGENT!


Tal wrote:
> The problem is when I draw a wire between to nets eagle ask me to
> what net add the new wire, it become the same net as I select it.

So don't do that.  Such topological changes to the circuit should only be
done in the schematic editor, not the board editor.

> later, I cant delete it but can only delete the *whole* net.

Of course, because there is only one net now that you connected them.

Again, if you want to connect two nets use the NET command in the schematic
editor.  If you want to break a net into two nets, you can then delete
individual connections in the schematic.  Otherwise, how to you expect your
schematic to stay in sync with the board?


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics