Harold Hallikainen wrote:
> I installed 6.4 at a client facility Monday and had a problem. I was
> in a rush to get out of town, so I did not dig deep enough to solve
> it. We're programming 18f6720 chips with ICD2. With 6.3, I could set
> the debug configuration bit to 0 to program the chip to run without
> the debugger. That config bit seems to have been eliminated. Is the
> debug/runtime decision now buried in some menu?

You have to chose the ICD2 as either the debug tool or the programming tool.
It can't be both at the same time.  Select as programming tool then do a
programming operation.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body