Hi,

 I want to check the voltage as I am charging a battery
 pack, by cutting the PWM, and using the ADC in sleep
mode. I plan on tying a resistor divider network between
 the zener and the battery and gnd. Something like this

 1Amp > | Battery Pack - Gnd

         R (1K)

 ADC PIN>>

         R (1K)

         Gnd
 Question, will this create problems for the ADC pin when
 charging the battery ?  Will the current/voltage feed
 into the ADC pin and damage it ?  1K is not a lot of
 protection. The highest current I will be charging at,
 is 1Amp.  If it will damage the pin, any suggestions on
 how to alter the circuit to protect it. I am using a
 16F88 and the data sheet says max impedance on ADC
 should be 2.5K not 10K like the 16F876.

 Thanks
 Kevin

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.