Just released!
My version on making thru-hole connections.
http://www.pic101.com/pcb/thru.htm
Rick C.

Bob Barr wrote:

> On Mon, 24 Nov 2003 10:30:33 +0500, Shahid Sheikh wrote:
>
> >> Double sided is OK with care.
> >
> >If you are looking for thru-hole plating, check out the
> >http://www.lpkf.com website. The EasyContac
> >(http://www.lpkf.com/others/1/233-rp_chapter_easycontac.pdf) is a manual
> >thru-hole plating process in which you basically flare open the ends of
> >a copper barrel after instering it thru the hole. That kit unlike the
> >rest of their products wasn't overly expensive either.
> >
>
> What pricing do they have on their kits? They list the cost of these
> little things at US$0.35 each. That could get real expensive real
> fast.
>
> Regards, Bob
>

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body