At 03:38 PM 11/14/2003 -0300, you wrote:


>The mur is 2 cm (1 inch) from the FET and the cables to the motor are
>about 40cm (16 inches)long.

The voltage rating on the FET is a little close, depending on the line
transients and inductances in your layout- consider increasing
it, though it will undoubtedly cost you more to get the same Rds(on).

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff@interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics