I made a circuit board to control a sensor. I converted an 18 inch, 15
pin, VGA cable To go from the Board to the sensor. The output of the
controller is at 3 volt Levels the sensor needs 5 volt levels. So I used
a 3.3 to 5 volt translator for the clocks. The problem is, at the sensor
the waveforms look terrible, ringing overshooting, and cross talking to
ground. They look OK without the
Cable, but still overshoot. Sensor Analog output looks Ok Then bad. I
tried putting resistors in series and parallel with the clocks.Helps a
little but output still schitzes out.
IS there anything I can do about this?
Im not an EE , just doin this for what I thought was fun.

Thx

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body