Thanks Olin

You help keep us new picer's on track. I should always double check with
the formula


Charles K Roberts II
ORNL-SNS Project


-----Original Message-----
From: Olin Lathrop [mailto:olin_piclist@EMBEDINC.COM]=20
Sent: Monday, September 29, 2003 5:07 PM
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [PIC]: Writing data out using USART

> I don't know if the values are correct or not, *but* the table is on
> page 112 in my data sheet (DS39582A, for the 16F87xA series of PICs).
> Page 98 doesn't have any table at all.
>
> What document are you using ? Perhaps the DS30292C ?
> Note that *that* document is for the 16F87x series of PICs.
> NOTE ! Not the "A" versions !
>
> Now, the tables *look* similar, but perhaps you'd better
> download the correct data sheet anyway...

Note that in any case the tables are just precomputed baud rate
generator
values for a few selected cases.  You don't need them at all.  You can
derive any of the table information from the formula.  I would double
check any buad rate generator value against the formula to verify it,
regardless of its source.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads