Stop the presses... I was wrong.  After more digging it appears that a PIC
is not used to decode the signal, it is used to operate the magnetic
actuators on the RFFS-100.  The PIC is on the backside of the board.   I am
not sure what chip the crystal is connected to on the front side... some
sort of a radio IC?  I was hoping to process the signal from the transmitter
using a single PIC input pin.

-----Original Message-----
From: Jeremy Darling [mailto:jdarling@ASKPIONEER.COM]
Sent: Tuesday, September 02, 2003 11:56 AM
Subject: Re: [EE]: RC (Radio Control) Receiver Project


  This question will actually require you to do much digging.  The first
question should be what transmitter are you going to use.  Since Futaba,
AirTronics, JR and the others do not use the same method to communicate (you
can see this by using 2 radios on the same channel, moving your throttle up
on one may cause the other to wag the rudder or some silly stuff).  Once you
know this you can move forward rather easily.  A simple crystal oscillator
based on the appropriate crystal set for your radio can be found in any
basic electronics book and then its just a matter of decoding the data
stream and driving the appropriate servos.

Contact the dealer of your radio of choice, and have a heart attack at the
price they want for the com spec, then start dissecting an existing
receiver.  Break out your scope and signal analyzer to see how it is
communicating.  Don't bother trying to build your own transmitter.  The
requirements from the FCC are very strict and they don't play around.

Jeremy

-----Original Message-----
From: Rubin, Dan [mailto:dan.Rubin@QWEST.COM]
Sent: Tuesday, September 02, 2003 10:31 AM
To: PICLIST@MITVMA.MIT.EDU
Subject: [EE]: RC (Radio Control) Receiver Project


I am sending this again because I forgot to include the proper tag.  I am
not sure if this question deserves the [PIC] tag so I am playing it save and
using [EE].

--

Hello,

I have been doing some digging to find some information needed to start a
new project to build a RC (radio control) FM modulation receiver for use
with 72 MHz aircraft frequencies based on one of the new PIC nanowatt chips.
I have come up with very little on the subject.  Has anyone run across any
relevent articles in the web or in this list that may help me?  An example
of an existing product can be found at
http://www.slowfly.com/DetailPages/rffs100.html.  Any ideas?

- Dan

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us! email
listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us! email
listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu