I got an answer from Microchip tech-support through their webboard: "I see the problem and apologize that this was not fixed sooner. I will place the request to get this repaired." So this is a bug one should be aware of. I thought this may be useful for others like me using MPLAB 6.xx and the simulator. Thanks RA ----- Original Message ----- From: "Reinaldo Alvares" To: Sent: Friday, August 29, 2003 12:47 PM Subject: [PIC:]Simulator stimulus in MPLAB IDE > I'm having some troubles to properly simulate in > MPLAB IDE 6.30. > I have set up the simulator stimulus as follows: > trigger on: PC, trigger value: 0x22, Pin/reg: portc, > value:c:\sim...\stireg.rsti > In the watch window the portc value updates correctly > according to the value from the file.The problem is > that in the status bar and in the address field of the > program memory window the pc shows 0x26 instead of > 0x22. If I change the triggering value to 0x20 then > the watch updates when the pc shows 0x24 etc. There's > always a difference of 0x02 between the trigger value > I have set and the value of the pc when the stimulus > actually happens.Any idea of what I'm doing wrong? > thanks in advance for any help. > RA > > -- > http://www.piclist.com hint: To leave the PICList > mailto:piclist-unsubscribe-request@mitvma.mit.edu > -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.