hello guys
as anyone tried the method of making PCB's detailed on this link?
if so what is the minimum track width that you can reliably do?
thanks
        Luis

-----Original Message-----
From: Rick C. [mailto:rixy@VVALLEY.COM]
Sent: 23 July 2003 14:58
To: PICLIST@MITVMA.MIT.EDU
Subject: Re: [EE]:Cutting PCB Boards


Go to:
http://www.pic101.com/pcb for some suggestions. Or google "making
quality printed"
Rick

>Hi All
>
>Has anybody tried using an office paper guillotine to cut PCB laminate
?
>
>A real cutter is quite expensive (for the amount of time I would need
>one), but I've seen some paper cutters quite cheap.
>They say they will cut up to 10 sheets - that's about 1mm, the PCB
>laminate I use is only 1.5mm, single sided.
>Once you remove the safety guards, they look a similar design.
>
>Any thoughts....
>
>Thanks.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu