Actually I just tried it, and just setting the drill diameter for that ne=
t=20
class works properly, so that is all you need to do.
(The DRC setting will want to set and verify for all drilled holes on the=
=20
board.)

Cheers,
-Neil.



On Wednesday 27 August 2003 01:39, Tal scribbled:
> Hi Neil
>
> Yes, you are assuming correctly :-) it's Eagle. sorry for the omission.
> So in DRC where it says drill size it mean for the *via* drill size onl=
y?
>
> Thanks
>
> Tal
>
> -----Original Message-----
> From: pic microcontroller discussion list
> [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Picdude
> Sent: Wednesday, August 27, 2003 9:44 AM
> To: PICLIST@MITVMA.MIT.EDU
> Subject: Re: [EE]: Via size in auto routing
>
>
> Shall I assume "Eagle" since this is the popular tool here on this list=
?
>
> If so, I believe you should find it under Design Rules.  There is a set=
ting
> for the minimum drill size.  Also, check under Net Classes -- there is =
a
> drill size setting for each net class.
>
> Cheers,
> -Neil.
>
> On Wednesday 27 August 2003 01:08, Tal scribbled:
> > Hi
> >
> > How I change the default via size that the auto router is placing?
> > the via size I get is too small and I want to enlarge it automaticall=
y
> > while the auto command is working.
> >
> > Regards
> >
> > Tal
> >
> > "I have not failed. I've just found 10,000 ways that won't work."
> > Thomas Edison
>
> ---
> [This E-mail scanned for viruses]

---
[This E-mail scanned for viruses]

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.