The RS232 Hex Com tool @ http://www.viddata.com may do what you need. A time-limited demo is available - it was enough when I had a similair requirement. Dean -----Original Message----- From: pic microcontroller discussion list [mailto:PICLIST@MITVMA.MIT.EDU]On Behalf Of Andrew Seddon Sent: 22 August 2003 15:39 To: PICLIST@MITVMA.MIT.EDU Subject: Re: [EE]: Hex terminal software Yeh I was hoping to avoid having to do that. It seems like such a common thing that somebody must have done it already! I don't need any terminal emulation. Just to be able to send TX/RX hex with flow control and preferably some debug stuff telling me which lines are high/low etc. Cheers. -----Original Message----- From: Jan-Erik Soderholm XA (TN/PAC) [mailto:jan-erik.xa.soderholm@ERICSSON.COM] Sent: 22 August 2003 15:33 To: PICLIST@MITVMA.MIT.EDU Subject: Re: [EE]: Hex terminal software Any emulation needed (such as VT-xxx, or ANSI) ? Maybe just hack up a serial comm app in VB that does what you want. It seems as you are going to test something ? Jan-Erik. Andrew Seddon wrote: >Can anybody recommend some terminal software with the following >functionality. > >1.) Ability to view and send raw HEX, preferably binary too. >2.) Hopefully some direct control over RTS, CTS (i.e see what the > current state's are and change manually) >3.) Free/Shareware >4.) The ability to pre-compile hex packets to be sent out on > command. >I've tried Docklight which seems ideal, except for the fact that it >doesn't allow you to use hardware flow control?? I`ve also tried a few >other programs all of which can receive in HEX but not TX. > >Any help much appreciated. -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details. -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details. -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.