-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

source= http://www.piclist.com/piclist/2003/08/18/130113a.txt?


I have logged into http://www.mouser.com and looked for some parts.  I see
these Mouser part numbers.

571-5551651       $0.53 AMP Modular Jacks
571-5551631       $0.60 AMP Modular Jacks
538-22-14-2064    $0.84 Molex 0.100" K.K. Connectors    (does this mate
with 538-22-01-3067 ? )
649-68685-306     $1.55 FCI Dubox PCB Connectors
517-850-01-08     $1.37 3M Board Mount socket (8 pin)


I am not drawn to the RJ connector, because of difficulty making cables.

I want to use sockets, not pins, on the PCB.  For mated boards, I would use
sockets on both PCBs and pins to connect them.  Don't have a representative
part number

I placed the 3M connector on the prototype PCB that I am working on, and
use jumper wires to the programmer.  It works ok.  I will have the Rev 2.
PCB specify a 0.100" X 6 pin area, add the PGM (RB3) to pin 6.  I will
order the 6 pin, and other parts that this list comes up with.

If all goes well, the Rev 2 board will show up in Nuts & Volts, so don't
feel shy (not that it's been a big problem)


Am Montag, 18. August 2003 17:51 schrieben Sie:
>At 03:16 PM 8/18/2003 +0000, you wrote:
> >We've chosen to use the pin out used on the ICD-2. That is:
> >
> >1 - -MCLR
> >2 - Vcc
> >3 - ground
> >4 - PgD
> >5 - PgC
>
>Same here, just on a 100 mil pitch inline header. Or pogo pins. The RJ
>connector is too bulky and expensive for one-time use.
>
>If extra connections are needed, they are added to the core ICSP
>programming connections.
>
>Best regards,
>
>Spehro Pefhany --"it's the network..."            "The Journey is the
>reward" speff@interlog.com             Info for manufacturers:
>http://www.trexon.com Embedded software/hardware/analog  Info for
>designers:  http://www.speff.com


I would use a jumper strip and standardise the signal layout for this jum=
per.=20
It would be easy to make some adaptors, that connect to the jumper strip,=
so=20
you'd always have the right connector type for any target circuit.

MfG,
Do.Pe.



- ---
Aubrey  McIntosh
http://www.piclist.com/member/AM-vima-Y84
PIC/PICList FAQ: http://www.piclist.com


-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 7.0.3 for non-commercial use <http://www.pgp.com>

iQA/AwUBP0FPXAKlSw8yssF7EQKRQwCguzaZefyWTeT0Qn/NLcKecaPNlugAoJTb
oedP1NSOwwhZQEPG9yf4Jo5b
=FYEf
-----END PGP SIGNATURE-----

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body