Am Montag, 18. August 2003 17:51 schrieben Sie:
> At 03:16 PM 8/18/2003 +0000, you wrote:
> >We've chosen to use the pin out used on the ICD-2. That is:
> >
> >1 - -MCLR
> >2 - Vcc
> >3 - ground
> >4 - PgD
> >5 - PgC
>
> Same here, just on a 100 mil pitch inline header. Or pogo pins. The RJ
> connector is too bulky and expensive for one-time use.
>
> If extra connections are needed, they are added to the core ICSP
> programming connections.
>
> Best regards,
>
> Spehro Pefhany --"it's the network..."            "The Journey is the
> reward" speff@interlog.com             Info for manufacturers:
> http://www.trexon.com Embedded software/hardware/analog  Info for
> designers:  http://www.speff.com


I would use a jumper strip and standardise the signal layout for this jum=
per.=20
It would be easy to make some adaptors, that connect to the jumper strip,=
 so=20
you'd always have the right connector type for any target circuit.

MfG,
Do.Pe.

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body