I don't know if this will help, but I used some thermally conductive potting resin from Epoxies Etc at one point www.epoxies.com. I just used it to glue a temp sensor to a heat sink but, it sounds as though some of their products may fit you need. Eric On Wed, 13 Aug 2003 21:17:38 -0700 Dan Devine wrote: > Hi, > > I'm looking for a good general purpose potting compound for some small > (3.2" X 4.0" eagle size) amplifier boards I'm working on. I have not > used potting compounds before, and need some guidance on what to look > for. > > Anyone have any recommendations?....what numbers are good?...I know I > need good thermal conductivity, I've got a power resistor and an > OPA548 on the board, so there will be some heat. Other than those, > I've just got some small op-amps and counters. > > Any suggestions on where or what to purchase? > > > Thanks, > > DD > > -- > Dan Devine > New World Industries > > -- > http://www.piclist.com hint: To leave the PICList > mailto:piclist-unsubscribe-request@mitvma.mit.edu -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu