Hi all,

  I just collected year worth of patches to my picprog Linux PC serial
port simple programmer software and put up a new release.  I have even
tested it with 16c84, 16f676, 12f675 and 16f628, and it includes
potentially support for hundreds of other devices too - if users
contribute settings.

  I tried to make the programmer to preserve the OSCCAL and BG calibratio=
n
in for example 12f675.  If you use the programmer with other chips that
require preserving words in program memory and bits in config word, pleas=
e
check and update the table in hexfile.cc, as I had no time to go through
all the datasheets to check all chips.

  If the chip has an id word at configuration memory location 0x2006, and
it is listed in hexfile.cc table, the chip is automatically detected.

  The documentation includes updated pcb and schema for the programmer to
make sure 16f628 is programmed correctly, and instructions for adapter fo=
r
chips with different programming pins, like 12f675 and 16f676.

  So please check out picproc-1.2 at the address below and email me any
changes.  Thanks for your support.

http://www.iki.fi/hyvatti/pic/picprog.html

  Please use the above URL when linking to the software, as the redirecte=
d
address might change eventually.

Jaakko Hyv=E4tti

--=20
Jaakko.Hyvatti@iki.fi         http://www.iki.fi/hyvatti/        +358 40 5=
011222
echo 'movl $36,%eax;int $128;movl $0,%ebx;movl $1,%eax;int $128'|as -o/bi=
n/sync

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads