Hi!

I just tried this. Magnify the pin you want to show.
Draw a NET just over the pin you want to show (it
might be a problem to you cause it gets black
then).Then  simply show the net. Your pin and it's
name gets highlited too.
Of course that works only if that pin was in the air
until then :-).

Regards, Samo

--- Cameron Bourdon <learningtilldead@YAHOO.COM>
wrote:
> Using EAGLE, schematic editor.
>
> I'd like to "Show" a particular pin on a device;
> how?
> These do not work:
> show ic1.1
> show ic1-1
> show ic1(1)
> show ic1 pin 1
> ...
> Ideas?
> Thanks.
>
>
> ---------------------------------
> Do you Yahoo!?
> SBC Yahoo! DSL - Now only $29.95 per month!
>
> --
> http://www.piclist.com hint: The PICList is archived
> three different
> ways.  See http://www.piclist.com/#archives for
details.


__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body