Are you removing the power to your circuit during programming?

Alex

> -----Original Message-----
> From: Mike Hord [mailto:gaidinmd@HOTMAIL.COM]=20
> Sent: Monday, July 14, 2003 4:06 PM
> To: PICLIST@MITVMA.MIT.EDU
> Subject: [PIC]: ICSP with WARP-13a
>=20
>=20
> I'm getting a lot of Comms 1 errors under Win2k with my=20
> Warp-13a. It only happens when I'm attempting In-Circuit=20
> programming; I can read/write from/to the chip in the socket.
>=20
> I'm using a PIC16F819...the LVP pin is RB3, and the Warp-13a=20
> docs state that that pin must be held low during programming.=20
>  Doing so does not help at all.  I'm using the latest 4k/4MHz=20
> firmware.  I can't seem to find anything on the website to=20
> suggest further "traps".
>=20
> Anyone have a similar experience that they've overcome?
>=20
> Mike H.
>=20
> _________________________________________________________________
> MSN 8 with e-mail virus protection service: 2 months FREE*=20
http://join.msn.com/?page=3Dfeatures/virus

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us! email
listserv@mitvma.mit.edu with SET PICList DIGEST in the body

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body