> Is that the same flaw as in the errata sheet regarding high and low
> priority interrupts?
>
> "Module: Interrupts
> Under certain conditions, the use of dual priority
> interrupts may cause a program instruction to
> skipped entirely. This has only been observed
> when both of the following apply:
> * Both high and low interrupts are enabled, and
> * A high priority asynchronous interrupt occurs
> in the following cycle after any low priority
> interrupt.
> The event causes the stack to get pushed twice,
> and will eventually result in an overflow."

No, this is a different bug.  This bug wasn't fixed until rev C0 silicon.


*****************************************************************
Embed Inc, embedded system specialists in Littleton Massachusetts
(978) 742-9014, http://www.embedinc.com

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body