> -----Original Message----- > From: Ken Pergola [SMTP:no_spam@LOCALNET.COM] > Sent: Saturday, July 12, 2003 3:14 AM > To: PICLIST@MITVMA.MIT.EDU > Subject: Re: [PIC] PIC as an RTC, is it recomended? > > Hello Mauricio, > > You *may* find out it will cost more not to use a specialized RTC chip, > but > it is worth investigating alternatives (time is money too). You may have > to > spend more money on a heftier lithium to compensate for the larger current > draw of a non-RTC solution (such as a PIC -- unless the nanoWatt devices > fit > the bill). > > Also if you have not already implemented the following on your PCB, please > do... > > Two side note caveats regarding your lithium battery: > > 1) It is always a good idea to place a current-limiting resistor (~470 > ohm) > in series with the positive lead on the lithium battery (as close to the > lithium battery as possible). You don't anyone accidentally shorting out > the > battery during PCB troubleshooting/testing and having a lot of current > dumping through a PCB trace. Not a pretty sight. > The OP is refering to a lithium coin cell, they have enough internal resistance that the chances of drawing enough current to blow a PCB trace is negligible. Mike ======================================================================= This e-mail is intended for the person it is addressed to only. The information contained in it may be confidential and/or protected by law. If you are not the intended recipient of this message, you must not make any use of this information, or copy or show it to any person. Please contact us immediately to tell us that you have received this e-mail, and return the original to us. Any use, forwarding, printing or copying of this message is strictly prohibited. No part of this message can be considered a request for goods or services. ======================================================================= Any questions about Bookham's E-Mail service should be directed to postmaster@bookham.com. -- http://www.piclist.com#nomail Going offline? Don't AutoReply us! email listserv@mitvma.mit.edu with SET PICList DIGEST in the body