> >> I was wondering if there is any way to route across an unused
> pin pad on
> >> an SMT PIC?  If I set up the pin as an output, then it is
> >> high-impedence, correct?  So, to the circuit it is not there?
> >
> >        You must set it as an input, not output, and even then
> the voltage on that
> >pin must not go outside the allowed input for a PIC pin. What
> about bending
> >that pin up so it doesn't make contact with the pad? Are you doing SMD or
> >through hole? You could just cut the pin off. TTYL
>
> This would be a VERY bad idea for a 'production' product, as it
> would cause problems when (not if)
> someone forgets to cut/lift the pin.

        I don't see why, the pin will already be set as input, so unless you are
doing something wierd with that trace the "cutting of the pin" is only a
backup.

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu