Kyrre Aalerud said:
> I have a little layout problem that I might solve if I could be safe on
> the current-capabilities of a 0Ohm SMD shunt.  It's a 1206 size.
> I've been diggin for half an hour and found nothing?
> Anyone here that can assure me I can push 1.5A at 5v through one of
> theese?

I expect it will vary by manufacturer, however 1206 and 0805 by Yaego are
rated at 2 amps.

-Bob

P.S. that was in the data sheet, third page. Also, since the maximum
resistance is listed as .05 ohm, 2 amps would be .2 watts, OK for 1206 but
a little high for 0805 size so maybe they aren't paying too much attention
to their own spec sheets. Personally I would think 2 amps is pushing it
for even the bigger one.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.