I have a project where I am trying to send rs-232 data one way over a
commercial low power radio module, & am trying to use a 16f627 to encode
the data on the transmit side & another 16f627 to decode the data on the
receive side.  I have no control over the rs-232 data, since it is being
generated by another device @ 4800 baud with only Tx & SG signals.  I am
very
new to programming PIC's, so I really don't even know where to begin.
Would anyone have any experience with this type of application, or have any
suggestions on where to start?  I have searched everywhere I can think of,
but all I have found so far have been general references to Manchester
Encoding, nothing detailed enough to get me started.  Any help would be
greatly appreciated.

Thanks,
David

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu