At 03:12 PM 5/15/03 +0500, you wrote:

>  However, as
>  soon as I disable the ICD executive code so that it runs in stand alone
>  mode, it doesn't work.   I've single stepped through it in ICD mode, and
>  see nothing that would cause it to stop working.   So my geuss is I'm
>  missing something when turning off the ICD mode.  What I do to disable
>  it is to uncheck the checkbox in the ICD options dialog near the bottom
>  that says 'Enable Debug Mode'.   When I do this, and reprogram the chip,
>  it should run in stand alone mode, correct?
>
>  Does anyone have any ideas or clues as to what I'm doing wrong?
>
>  If so, please reply to me ASAP at jpaul@appliedmems.com.


With the ICD2, it works for me exactly like you describe.

To get the target code to run, the connector to the target board from the
ICD2 must be removed as it asserts the reset line and holds the target chip
in reset.

Tom M.

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body