Hi everyone,

I built the ICD and ran into some problems:

When I try to program the target PIC, sometimes it programs OK and sometimes it says "Check for target:  Not exist".  Then when I click on the Option->Self Test, it says "Debug Module: Not exist, Incorrect MCLR pin low voltage.  Check ICD pi0x7020".  The VDD voltage = 4.75V, VPP = 13.71V.

The strange thing is sometimes even when I get the same error message in the "Self-test" above, it still detected the target when I press "Program" and programs the target fine.

Do you know what my problem is?  I have a 47k pull up resistor at the target.  I tried to change to 10K but it doesn't seem to make any difference.

Please help!  Thank you in advance!

Thomas


---------------------------------
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.