Hi.
Looking in the data sheet for the 16F628, I can see
no specified data for 9600 baud below 1Mhz Xtal freq.
Have anyone used the UART at 9600 baud at lower
speeds then 1Mhz ?

I'm looking at a (very) lowpower application, and
one (or "the") way to get low power is low speed, right ?
A couple of 100's kHz would probably be just fine.

It will just be a/some PIC talking on a serial line and
on non-volatile memory, probably FRAM due to the write speed.

The "other side" is fixed to 9600 baud.

Jan-Erik Soderholm

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu