I used the P16PRO40 for several months with in circuit programming and
it worked just fine. I used a DIL socket as an header, wires of 10-12"
and a plug at the other end that plug into the board. If I recall
correctly, I even did not have to unplug the programmer when running the
firmware (currently we are using Warp13a and have to disconnect the plug
each time after we program the PIC).

Tal

> -----Original Message-----
> From: pic microcontroller discussion list
> [mailto:PICLIST@MITVMA.MIT.EDU] On Behalf Of moonshadow
> Sent: Friday, May 02, 2003 10:47 AM
> To: PICLIST@MITVMA.MIT.EDU
> Subject: P16PRO40 In circuit programming ?.
>
>
> I have a P16PRO40 programmer and wondered if anyone has
> modified theirs to program PIC's in circuit ?. I was thinking
> along the lines of a dil header to plug into the programmer
> .... cable ..... Icp connector to development board ?.
>
> Thanks. John Kent.
>
> --
> http://www.piclist.com hint: PICList Posts must start with ONE topic:
> [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads
>

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads