Joe,

there is an article I have a copy of about drilling holes in glass.
I have emailed it to you (400k in size.. apologies)

Basically the  article describes everything you need for small holes, and =
large.
I got the article from a group on yahoo but can't remember which otherwise =
I'd have posted the URL.

Des

>>> joecolquitt@CLEAR.NET.NZ 2/05/03 11:49:12 am >>>
I've got some ideas for using electronics with glass (1.5-3mm) and
would like to drill holes in the glass to pass wires, mount LEDs etc.
I went into a local glass supply store and was told that diamond drills,
which according to the web appears to be the recommended way,
start at $200. Ouch. Or I could have them do the holes for me at $6
each. Ouch. They suggested cobalt twist bits as a poor 2nd choice.
I've some 1mm PCB Co drills which might do for wires but I'm not
banking on it.

As I'd planned to do some bending and sealing with a gas torch one
other possibility is to use a small tip with oxy-acetylene and blow a
hole, but that seems like a pretty crude way to do it, and there could
be problems with heat and cracking

Any other ways that might be worth looking into ?

TIA

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu