At 07:39 PM 29/04/03, you wrote:
>The grid errors are caused because many parts, although they have been
>placed on the grid, have pins that are not on the grid.
>
>Bob Ammerman
>RAm Systems

I did a complete board using the default 5thou grid and other than one
angle/pad
error it was ok. I was able to fix the angle error.

Now if I could figure out how to snap parts back onto the grid once they
were placed off
I could save the other board. In cad that easy to do by selecting with the
grid off  then
turning it on to place.but I couldn't get Eagle to do the same thing.

Oh well after the initial freak out I learned a bit ;-]

Dave

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body