The grid errors are caused because many parts, although they have been placed on the grid, have pins that are not on the grid. Bob Ammerman RAm Systems ----- Original Message ----- From: "Dave King" To: Sent: Tuesday, April 29, 2003 8:41 PM Subject: [OT]: Eagle Errors?? I was working on a board today and made the mistake of turning on the angle and grid in DRC. Now I have a flood of errors on this board. The angle errors are weird as they occur even on autorouted segments. It supposedly is just checking for multiples of 450's The grid errors are saying the pads are not on the grid, again a strange error as the grid was used from the first step. I've nudged a few guilty parts around but am still getting the error. Other than starting a new board anyone have any ideas? TIA Dave (I'll post this to the eagle group later) -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details. -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.