Hi,

Olin Lathrop wrote:

>>>> During these conditions: 5V, 25C=3DB0, 3.6864Mhz * 4 (pll) =3D3D
>>>> 14.7456Mhz 2 out of ten never worked in at room temp, one started
>>>> working after about 10 minutes, additional 2 stopped working when
>>>> I put cooling spray onto the chip (temp< 5C=3DB0). An total of 4/10
>>>> that was subject for the errata.
>>>
>>> You run them out of spec, then complain they won't work!!!???
>>
>> What part of that is out of spec?
>Less then 4MHz with PLL enabled.

Yes, I forgot to add that during the test I had an 14.7456Mhz
crystal connected and used no pll. Sorry to incorrectly state the test
setup.=20
As stated they were out of spec. Normally the product uses an
7.3728 MHz with pll, however my test setup was I bit different,
I started out with 3.6864 Mhz crystal before I spotted the condition
(for use without pll) and then replaced it. My mind was a bit weary
when writing the mail to the piclist.

However using the 14.7456Mhz and no pll produced the outcome according
to my mail.=20

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu