From: "Peter L. Peres" <plp@ACTCOM.CO.IL>
> My problem with pre-sensitized boards is a) price and b) the fact that the
> resist chips off if I try to cut them to shape before exposure. My boards
> are small and I can use a sheet of pre-sensitized for a long run of
> prototypes if I can cut it. But I cannot. So I use the spray.

How to you cut it when you manage to get the photoresist to chip?
I cut mine with a sharp knife making a deep groove on each side of board and
simply snap it.
On thinner boards like 0.8mm I simply cut with a large pair of scissors.

    KreAture

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads