Hello all,

 I thought the next step-up for me in the EE world would be to finally try my
hand at creating my own PCB's instead of using damned Veroboard. I have been
reading up on the etching process and it's requirements, so I have just a few
questions. Most importantly, how did you guys make your etchant tanks? What do
you recommend for someone starting? Keep in mind cost is an issue, and I don't
need something high-tech at all. From what I understand, basically all you need
is a glass tank of some sort, a bubble generator, and some etchant solution. Is
there anything else? I guess if I could get recommendations on all three, it
would help me out a lot!

Thank you everyone,

Jai



----------------------------------------
This mail sent through www.mywaterloo.ca

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu