All the settings are fine. I just took it from PicStic programmer so it should be fine. Cable is about 4 feet long. It seems to be able to drive LEDs well. I don't think this is what the problem is. How long should the cable be? >From: Jai Dhar >Reply-To: pic microcontroller discussion list >To: PICLIST@MITVMA.MIT.EDU >Subject: Re: [PIC]: PARPIC AND TAIT's FPP programmer >Date: Mon, 17 Mar 2003 21:58:01 -0500 > >Did you select your device settings right in FPP? Under the 'setup' button, >there are some options you should look at. And I'm not sure about PARPIC, >but >cable length might be an issue. Try shortening the cable... > >Quoting Konstantin Klitenik : > > > I built PARPIC and downloaded FPP programmer. When I try to program the > > PIC, it immediately says "Failed to program code!" It doesn't seem like >it > > even tries to program. I have installed GIVEIO.SYS and if I go to test, >it > > seems to be able to control the pins. I double checked my circuit >several > > times and everything there seems to be fine. It seems like FPP doesn't > > detect the programmer. The port setting is correct (378). Does anyone >know > > what could be wrong? TIA. > > > > _________________________________________________________________ > > Add photos to your e-mail with MSN 8. Get 2 months FREE*. > > http://join.msn.com/?page=features/featuredemail > > > > -- > > http://www.piclist.com hint: To leave the PICList > > mailto:piclist-unsubscribe-request@mitvma.mit.edu > > > > > > >---------------------------------------- >This mail sent through www.mywaterloo.ca > >-- >http://www.piclist.com hint: To leave the PICList >mailto:piclist-unsubscribe-request@mitvma.mit.edu _________________________________________________________________ MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*. http://join.msn.com/?page=features/virus -- http://www.piclist.com hint: To leave the PICList mailto:piclist-unsubscribe-request@mitvma.mit.edu