Hi all,

I will appreciate very much if ant can help me to configure a JDM Serial
programmer, to work with the ICProg V. 1.04C.
I have selected the JDM programmer from the dialog box hardware selecion
option.
The Cable between the com port db-25 and the db9 card conector is
 2 - Tx - 3
20 - DTR - 4
 7 - GND - 5
 4 - RTS - 7
 5 - CTS - 8
Configured with Com2 Port
Direct IO Interface
IO Delay 10
My problem starts trying to select wich signal must be inverted or not, I am
trying many combinations with no good results, allways I have the same error
after the verification step of the program. VERIFY FAILED AT ADDRESS 0000h
I need to program a PIC16F877 as soon as possible !

Regards,

Augusto

--
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email listserv@mitvma.mit.edu with SET PICList DIGEST in the body