Hello,

I am designing a PCB for a motor controller I have developed for a small =
underwater vehicle being developed at the University of Victoria =
(www.engr.uvic.ca/~auv).  I have a few concerns about putting up to 20A =
through a PCB trace though.  By searching the web I have been able to =
find a nice program by John Brown (http://hampcb.com/downloads.html) =
that calculates the maximum current carrying capacity of a copper trace =
based on the acceptable temperature raise above ambient, trace width, =
and copper thickness.  This is exactly what I am looking for except I =
have been unable to determine what an acceptable temperature raise above =
ambient is.  At what temperature will the copper trace start to peal off =
the board?

This program indicates that with a trace width of 300 mils, an allowable =
temperature raise of 50 degree C, and 1 Oz copper plating I can handle =
21A - does this sound reasonable?

In the same vein, can I put 20A though a throughhole with a pin (i.e. =
through the leg of my MOSFET from on side of the board to the other) =
without taking special precautions? I realize I can't put 20A through a =
simple via, but am not sure if I can do it with a throughole with a pin =
in it.

Sorry for all the questions and obvious lack of knowledge, but this is =
only my second PCB and the first that has carried any serious current.

Thanks,
Donovan

--
http://www.piclist.com hint: To leave the PICList
mailto:piclist-unsubscribe-request@mitvma.mit.edu