Howard;

If I understand your question correctly you are asking how thick will =
the copper be in a plated-through hole on a PCB. That will only be about =
1 mil (0.001") thick.

But I would suggest you just specify the diameter of the finished hole =
and let the board shop select the drill size.

Regards,
Glen

-----Original Message-----
From: Howard McGinnis [mailto:mcginnis@E-VISIONS.COM]
Sent: Wednesday, March 05, 2003 8:02 PM
To: PICLIST@MITVMA.MIT.EDU
Subject: [PICLIST] [OT]: Eagle Question re Drill size


I'm creating a part for a TDK DC to DC converter that has 0.04 inch
diameter pins. In selecting the drill size, what allowance should I make
for the eyelet thickness?

Thanks,
Howard

Howard McGinnis
Electronic Visions, Inc.
mcginnis@e-visions.com
www.e-visions.com

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.