----- Original Message -----
From: "Jan-erik Soderholm (QAC)" <Jan-erik.Soderholm@PAC.ERICSSON.SE>
To: <PICLIST@MITVMA.MIT.EDU>
Sent: Wednesday, March 05, 2003 9:55 PM
Subject: Re: [EE]: Eagle vs. AutoTRAX (derailing to editing parts w/each)


> I did a 12F629 in AutoTRAX yesterday (after beeing a "user" of
> AutoTRAX for aprox 20 min.) I have done 12F629 in Eagle before
> after beeing a user of Eagle for a couple of month.
>
> I don't think I'd been able to make the part in Eagle at all, if not
> having a guide I found on the web.
>
> AutpTRAX was, in this respect, much easier to grasp as-is.
>
> *BUT*, right now, I can start AutoTRAX, but when loading my simple
> example schematic, I get a memory access error "The memory could
> not be "read"" on address 0x0000011c... P-III, 800Mhz, 128Mb, W2K.
>
> Jan-Erik.
>
If you don't mind me asking Jan, what sort of programmer and software are
you using to program the 12f629?

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.