> > I want to make rb0 on my 16f84be an input for a
> > pushbutton and the rest of portb outputs.  so far I
> > have not been able to create working code.
>=20
> Enable port B passive pullups in OPTION_REG, then connect=20
> the pushbutton between the port B pin and ground.  The pin will=20
> read 1 normally, and 0 when the pushbutton is pushed=20
> (assuming normally open, which most of them are).

   Use soldering-iron to connect wires of a pushbutton to PCB or
connector. Don't forget to plug in the iron (when cold it can't solder).

Good luck.
Mike.

--
http://www.piclist.com hint: The list server can filter out subtopics
(like ads or off topics) for you. See http://www.piclist.com/#topics