At 01:19 PM 2/8/03 +0100, QAC wrote: >Hi. >Next week I plan to make a visit to an auction where >all inventory of a large PCB factory is sold. >I'v seen that they have a number of "Carbide Drills" >in sizes from 0.25 mm up to aprox 6 mm. > >Whould there be any interest from the list members in >these drill bits if I can make a good price on them ? >And if so, what sizes ? The best buy I've ever gotten on Carbide PCB drill bits was US $5.00 per case of 50. However, I normally pay around US $10.00 per case of 50. I'm pretty sure these are re-sharps as opposed to new but they seem to work great - I get tens of thousands of holes out of them before they need to be replaced. I have no problem getting small bits (#60 and smaller) but have a hard time finding larger sizes at these prices. Depending upon what you can get them for, I'd be interested in a case each of #52, #55, #58 (.0635", .052", .042"). dwayne -- Dwayne Reid Trinity Electronics Systems Ltd Edmonton, AB, CANADA (780) 489-3199 voice (780) 487-6397 fax Celebrating 18 years of Engineering Innovation (1984 - 2002) .-. .-. .-. .-. .-. .-. .-. .-. .-. .- `-' `-' `-' `-' `-' `-' `-' `-' `-' Do NOT send unsolicited commercial email to this email address. This message neither grants consent to receive unsolicited commercial email nor is intended to solicit commercial email. -- http://www.piclist.com hint: The PICList is archived three different ways. See http://www.piclist.com/#archives for details.