I need to send from a PIC USART to control two devices, one being a display,
requiring commands & data, the other being another PIC requiring basically
the same. Other than doing the obvious, is there a simple hardware method
that can be implemented to address two devices on the receiving end? I do
have an extra pin that can be used to control which...I am thinking of some
standard logic in h/w, but I am hoping not to need another chip on this
board, unless it is very small...

TIS,
Chris

--
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads